View Full Version : how snug should hubcentric spacers fit?

10-29-2011, 10:29 AM
I installed ecs 15mm on all for corners and for some reason or another the spacer doesn't fit too tightly on passenger side rear. As a result there is some noise during turns. When I pull the wheel off, the spacer usually falls right out. The others stay snug in the wheel, not on the hub. Is there any danger in that spacer being a little loose. If the bolts are torqued properly, does it even matter?


10-29-2011, 12:15 PM
I have two that stick to the hub and the others come off with the wheel. Both sides seem to ride fine.