PDA

View Full Version : Best adjuatable FPR stock fit?



bmarshall
10-10-2011, 04:51 PM
Which stock fit adjustable FPR is the better option, 034, ECS, eurospec or others?
I read somewhere some cannot use the stock clip?

audikid66
10-10-2011, 05:04 PM
i had ecs adjustable on my BAT a4 and it was great just like stock

-:vw:-
10-10-2011, 05:42 PM
I can't speak for installation or the other FPR's you mention but my car came with the 034 via the PO. I've tinkered/adjusted it here and there and it seems pretty solid fit's in the OEM rail just fine from what I can see.

Seerlah
10-10-2011, 07:04 PM
I have a TM Tuning one, but have not installed it yet (not going on the stock rail, but a high flow one and will be used for my turbo setup).

Avant Nate
10-10-2011, 07:51 PM
034 is a lot cheaper.

spindoctor
10-11-2011, 02:27 AM
Which stock fit adjustable FPR is the better option, 034, ECS, eurospec or others?
I read somewhere some cannot use the stock clip?

Ben, my ECS tuning adjustable FPR should arrive soon via Marc of Ingolstadt Autosport.

I think Serkan(prodrive on AZ) has got one on his 525whp A4.

BaconBait
10-11-2011, 06:19 AM
I have the Eurospec. I had to ground down the clip a little because the body of the fpr is larger than stock.

ECS Tuning-Audi
10-11-2011, 08:09 AM
Our adjustable FPR is available below.

Click HERE to order or for more information. (http://www.ecstuning.com/Audi-B5_A4-Quattro-1.8T/Engine/Fuel/Pressure_Regulator/ES5271/?salesrep=JMarusic&utm_source=audizine&utm_medium=forum&utm_content=JMarusic&utm_campaign=postreply)
http://c1552172.r72.cf0.rackcdn.com/151608_x600.jpg (http://www.ecstuning.com/Audi-B5_A4-Quattro-1.8T/Engine/Fuel/Pressure_Regulator/ES5271/?salesrep=JMarusic&utm_source=audizine&utm_medium=forum&utm_content=JMarusic&utm_campaign=postreply)
Let me know if you have any questions.

Jason

SR-71
10-11-2011, 09:41 AM
I'd got with Integrated Engineering: http://www.intengineering.com/Integrated-Engineering-p9720030-1-2.html

mysman
10-11-2011, 01:44 PM
Depending on your setup, the fuel pressure range of the AFPR is more important. The ECS adjusts to below 3bar, which is what I needed.

bmarshall
10-11-2011, 09:10 PM
Im running a k03-073 on AEB k03 1 bar software. I have not run on a dyno yet to check AFR but its got more over the k03-005 right through the rev range. Im fairly certain AFR are fine though
I want to install meth and electronic boost control for around 18-20psi so was going to tune AFR with adjustable reg. I will have to get a wideband O2 meter too.

nam3
10-11-2011, 09:28 PM
I have eurospec, bought it reallll cheap from kijiji classifieds lol.

mysman
10-12-2011, 08:08 AM
I don't think you want to run 1bar software for the Frankenturbo on your AEB narrowband. You'll at least need bigger injectors and a larger MAF.

bmarshall
10-12-2011, 07:52 PM
Its not a real frankenturbo, its pretty much a k04.