nurve
03-25-2011, 05:36 AM
I have a complete, flanged 3 section, 3" stainless steel exhaust custom fabricated by Proven Power of Tampa. Bolts up like a manufactured turbo back exhaust. 3" downpipe, to midpipe, reduced and split to 2.5" to each muffler at the Y. This was $1200 fab'd, looking to get $800 obo. This exhaust setup can handle 600whp, does not include mufflers. Ground clearence is almost OEM, no scrapes or bottom outs, dents, damage etc. This exhaust is less than 4 months old.
http://i80.photobucket.com/albums/j161/quikcivic/welds2.jpg
http://i80.photobucket.com/albums/j161/quikcivic/weld1.jpg
http://i80.photobucket.com/albums/j161/quikcivic/fullex.jpg
http://www.tamparacing.com/forums/proven-power/706410-2002-audi-a4-proven-power-custom-exhaust-fabrication.html
Complete fabrication thread
727 455 7425
Thanks,
-Jared
http://i80.photobucket.com/albums/j161/quikcivic/welds2.jpg
http://i80.photobucket.com/albums/j161/quikcivic/weld1.jpg
http://i80.photobucket.com/albums/j161/quikcivic/fullex.jpg
http://www.tamparacing.com/forums/proven-power/706410-2002-audi-a4-proven-power-custom-exhaust-fabrication.html
Complete fabrication thread
727 455 7425
Thanks,
-Jared