People with Votex side skirts

[AWDTURBO]

I noticed when i installed the side skirts that there is no where to jack up the car? for those of you who jack up your car how do you do it?

I need a lift in my garage!

[AWDTURBO]

Phil i need your input :)

[ggg20t]

Doesn't that little jack support rail that runs kind of parallel to the rockers under the car, stick down lower than the Votex sideskirts a little?? i was thinking about picking these up... so this is good to know

[crazytex21]

Eagle make a small lift that you could put in your garage for under 2 grand! can you not use a floor jack?

[psiaddict85]

there are cut outs in the side skirts under the jack points.

[beantown]

there are cut outs in the side skirts under the jack points.

Yup, they do. There are actually arrows etched in the moldings (two on each skirt) which point to the jack point.

[AWDTURBO]

but no space for the jack stands :( i guess this will do

[AWDTURBO]

how bought at a shop how would they lift the car using the lifts that have the arms?

[psiaddict85]

how bought at a shop how would they lift the car using the lifts that have the arms?

There's enough room.

[beantown]

I think it depends on the arm-type of the lift. My local shop can't put my car on their lift anymore because it will potentially crack the skirts.

[crazytex21]

if i am not mistaken, i think some arms have bases at the end that are threaded, so the bases can be raised or lowered.

[deeznuts]

i have the DTH carbon sideskirts on, and im pretty low....i use a hockey puck accompanied with a low profile jack

[psiaddict85]

I think it depends on the arm-type of the lift. My local shop can't put my car on their lift anymore because it will potentially crack the skirts.

They won't crack. I've tried that already and the sides are very flexible around the jack points, just have to be gentle with them that's all.

[fly300kts]

Phil i need your input :)

I put the jack ni the cut out and the stand under the chassis

phil

[beantown]

i have the DTH carbon sideskirts on, and im pretty low....i use a hockey puck accompanied with a low profile jack

Haha, I do the exact same thing, except use a small wooden block.


They won't crack. I've tried that already and the sides are very flexible around the jack points, just have to be gentle with them that's all.

No, you're correct...I should have been more specific. I meant to say that the paint* could crack/bubble.

[AWDTURBO]

Lifted the car this weekend thanks for the info ..