alexbak
12-26-2010, 04:58 AM
Hey all! I've been a lurker on here for a while, need some advice. Complete car newb - in process of OEM RS4 rear sway bar install on my B7 A4, and having some trouble:
The left side end link bold came out just fine with a bit of force to break the thread lock, but the right side end link bold does not remove - it just spins the cylinder assembly in place when I turn the wrench. Was wondering if anybody else has had this problem, and whether or not it would be a good idea to position a vice grip where indicated in the picture below, and rest the vice grip along the upper control arm so I have both hands free to break the bolt loose. Thoughts? Thanks a lot
http://img135.imageshack.us/img135/3174/carright.jpg
The left side end link bold came out just fine with a bit of force to break the thread lock, but the right side end link bold does not remove - it just spins the cylinder assembly in place when I turn the wrench. Was wondering if anybody else has had this problem, and whether or not it would be a good idea to position a vice grip where indicated in the picture below, and rest the vice grip along the upper control arm so I have both hands free to break the bolt loose. Thoughts? Thanks a lot
http://img135.imageshack.us/img135/3174/carright.jpg