View Full Version : Disconnecting HIDs
greensto
12-15-2010, 07:29 PM
Where do you put the screwdriver to disconnect the wire housing? I dont want to break any of the flimsy plastic!
http://i955.photobucket.com/albums/ae31/greensto/photo5.jpg?t=1292469992
Mantvis
12-15-2010, 07:30 PM
right in the hole that u see! :D
then there should be 2 tabs on each side [wrench]
greensto
12-15-2010, 07:32 PM
Anyway you can photoshop where you are talking about lol. I purposefully took a pic of 3 holes the screwdriver can go in!
fly300kts
12-15-2010, 07:34 PM
Insert a screwdriver in the slot, lift and pull. I just told you
http://i31.photobucket.com/albums/c395/fly300kts/photo5.jpg
phil
greensto
12-15-2010, 08:14 PM
Gottit! Thank you. I guess there was just some dirt build up around the HID housings and it didn't want to budge at first (and I didn't want to pry too much and have something break).
UPDATE: I am putting my votex sideskirts and votex spoiler on by this weekend :)
fly300kts
12-16-2010, 04:45 AM
Gottit! Thank you. I guess there was just some dirt build up around the HID housings and it didn't want to budge at first (and I didn't want to pry too much and have something break).
UPDATE: I am putting my votex sideskirts and votex spoiler on by this weekend :)
Votex spoiler on a DTM bumper? Cm'on Man
Phil
greensto
12-16-2010, 04:49 AM
Votex spoiler on a DTM bumper? Cm'on Man
Phil
Votex 3-piece TRUNK spoiler man!
B72.0T
12-16-2010, 05:42 AM
Good job man!