PDA

View Full Version : 150psi oil Pressure Gauge and Sender



-:vw:-
12-05-2010, 11:58 AM
I just wrapped up installing a VDO 150psi oil pressure gauge and sender and it doesn't seem to be operating correctly. At idle it reads 120psi +/- when I hit the gas it drops down and then springs back up. I've had this happen before and if I remember correctly it was an incorrect sender? Is that the case here? I grabbed both the sender and the gauge from 42 Draft Designs so I'm assuming they sent the right hardware.

walky_talky20
12-05-2010, 04:18 PM
What is the approximate oil temperature when it shows this behavior? What oil temperature range have you tried it with?

.Mad Hatter.
12-05-2010, 04:35 PM
what he said.

my idle is like 75 +/-

-:vw:-
12-06-2010, 06:09 AM
It's the wrong sender. I forgot I DIDN'T order them both from 42 so I have mismatched hardware. The sender is the wrong OHM's for the gauge, I just ordered a different gauge to match the sender I just installed. It's to cold to switch senders again + a new gauge was cheaper than the new/correct sender. Thanks guys.