View Full Version : Radiator upper flange/connection

10-21-2010, 09:02 AM
I need to replace the radiator, but can't figure out how to get the upper connection on the passenger side off. I tried to wiggle it out (assuming it is an O-ring connection) but it won't come off. I don't want to break anything.

Can someone chime in how it comes off?



10-21-2010, 01:57 PM
that is the tranny cooler line, are you sure its not threaded it, if it isnt then just pull harder

10-21-2010, 02:49 PM
No, its a hard line, and has that flange on it that bolts it to the radiator. Just like the 2 lines coming out of the trans. So I am 90% it is just an O-ring seal, held in place by the flange bolt. But wanted to make sure I am not braking anything (and the hose/tube must be reused for the new radiator0.

I will spray a little PB Blaster on and wiggle/hubble/wedge a bit harder.

10-21-2010, 03:25 PM
Is this antifreeze or tranny fluid going through here?? recently found a leak on bottom side leaking from shiny circle metal connector. I didn't know how it was attached though. should i be worried that my bottom connection is dripping slow for a month now.. ive noticed coolant go low a few times.

10-25-2010, 04:22 PM
Took quite a bit of force (slotted screwdriver, wedged in) plus wiggling to get it out. O ring seat corroded is what made it a bit harder.