PDA

View Full Version : who makes a 2.75" catback?



4inchMAF
01-14-2009, 12:05 PM
i have to get a new catback. the 2.5 inch one (that came with the car when i bought it) that is connected to my 3" DP has the worst bends in it (crush bends). the person that had it before had a custom exhaust made. it was terrible!! it is LOUD as hell and the bends must be just as restrictive as stock...
i cant find a 2.75" anywhere ive looked so far...
thanks guys!!!!

quattro_mds
01-14-2009, 12:17 PM
I believe you're looking for either a Milltek or Neuspeed exhaust system. There be others but this is what comes to mind first

PreLunatic
01-14-2009, 12:19 PM
i have to get a new catback. the 2.5 inch one (that came with the car when i bought it) that is connected to my 3" DP has the worst bends in it (crush bends). the person that had it before had a custom exhaust made. it was terrible!! it is LOUD as hell and the bends must be just as restrictive as stock...
i cant find a 2.75" anywhere ive looked so far...
thanks guys!!!!

Get it custom done by someone who knows wtf there doing.

andyrew
01-14-2009, 12:35 PM
Your local shop makes them. Tell them to use mandrel bends, if they dont have them go to a shop that does, if no one has them (which they should, or should be able to buy them) ask them what they would need (aka 3 45 deg, 1 180 deg, ect)

Go 3". with 2 mufflers (or one muffler and a resonator). Find out what glasspacks they have available, anything similar to magnaflow should be good.

Poopie
01-14-2009, 12:38 PM
milltek does, but a custom one would be cheaper

mike-2ptzero
01-14-2009, 01:26 PM
milltek does, but a custom one would be cheaper

Unless you grab one when they have their 15-20% off sales. Thats how Jake got the one for his Dad's B6. But then it got modified to 3" to the Y.


034 sells a 3" exhaust for the B5. IIRC its around $725