PDA

View Full Version : BT guys, show me your intake setup please.



$teady$upreme
11-14-2008, 12:10 AM
Prefer intake setup with MAF.

I am about to make my own, but i have a ATP inlet for gtrs elim and it won't work on gt28rs. I notice the square box ATP inlet has N75 nipple and DV hole for it, so how can i transfer it to my gt28rs?

Here is what im thinking:

gt28rs > 3" ID 90* silicone hose > hard pipe with nipple for evap > hump hose > VR6 MAF > 3" ID 3" length hose > cone filter

But im still missing the nipple for the N75 and DV bung, or is there a different way to set it up.

Or should i just run a HKS BOV, will it be an easier setup?

sean1.8t
11-14-2008, 12:52 AM
search audisnapr.

he had quite the intake setup on his 28rs back in the day.

and the "show me your intake" thread had some BT intakes in there. i'd take a look if you haven't already.

and i'd post mine. but to MAF here [:)]

Russell2686
11-14-2008, 06:42 AM
http://i46.photobucket.com/albums/f106/Russell2686/CIMG1084.jpg

JumboBlack1.8
11-14-2008, 07:40 AM
Back when I was using an MAF, I used both the hard pipe and the two fittings on the square metal box from the ATP inlet to make an intake.......drilled some holes into the hard pipe and used the small nipple for vacuum, and the large brass fitting to recirculate my DV. However, with an MAF, the setup had to be plumbed fairly low in the engine bay (watch out for puddles!)

Right now on my MAF-less file, I'm running just a 3" 90degree silicone to the ATP hardpipe to a 3" filter. Though a TIP isn't necessary for me, I'm using one of the bungs on the hardpipe to recirculate my catch can

heres a bad pic
http://i229.photobucket.com/albums/ee167/FattieJayMack/DSC03017.jpg

fred2ka4
11-14-2008, 07:54 AM
This is a setup that I made using a Fujita dry superflow intake that has a built in Velocity Horn. The piping is 2.5" with a 2.5 - 2.75 step-up connector hose for the MAF. They sell the filter with a 2.75" opening so that there would be no transition but I already had the piping made.

http://i78.photobucket.com/albums/j91/fred2ka4/customintake026.jpg


http://i78.photobucket.com/albums/j91/fred2ka4/customintake031.jpg

dougyfresh
11-14-2008, 08:29 AM
http://i46.photobucket.com/albums/f106/Russell2686/CIMG1084.jpg

[>_<]

$teady$upreme
11-14-2008, 08:49 AM
Here is my current setup for my gtrs elim,
http://img.photobucket.com/albums/v201/SteadySupreme/Audiz/Olym238.jpg

Check the ATP inlet block, there is the DV brass fitting and small nipple for N75. For my new setup, im going to use a 90* silicone elbow, how can i have those two things on my silicone elbow?