PDA

View Full Version : loose PS pulley



EOD-5
11-01-2008, 08:26 PM
ok so...i havent driven my car in a few weeks cause i needed to replace my rotors....anywho

i started it up and it was making a weird clunky noise...looking around the engine bay i noticed the PS pulley was not straight...it was at a slight angle...and that also the shaft it mounts over (i guess) was a little exposed...and well as the washer shaking around

i know this is not good so im not driving it ATM...but anyone have any insight on this? is it possible to just tighten the pulley down....i really really dont want to have to take off the whole front end off to just fix this

any ideas id love them

EOD-5
11-02-2008, 05:36 PM
no one??