View Full Version : snub mount

10-15-2004, 05:09 PM
i want to install my gs snub mount tomorrow, and i looked under the car today, and didnt really see where it should go...

i saw one part, that looks like its it, about the same size, and its a soft rubber now... at the bottom of the radiator, dead center of the car...

but thinking about it, i dont see how this mount will make any bit of difference in the car...?

can someone point me in the right direction?

10-15-2004, 05:20 PM
I havent installed one but I am pretty sure thats where it goes.

The point of the snub mount is to remove the excessive flex between the motor and the chassis. Less flex = quicker response.

10-15-2004, 05:35 PM
That's it. It helps, believeit. My old one was shredded and without it you would definitely notice.

Search man, there are plenty of pics and info.




10-15-2004, 06:28 PM
the hole in mine doesnt go all the way through the mount..?

A4 in SC
10-15-2004, 09:39 PM
If you're talking about the same thing -

IT SHOULD! You'll definitely tell a big difference if your snub mount isn't properly installed now!


10-15-2004, 10:01 PM
its not installed yet, but it doesnt have a hole all the way through it.. your saying it should?


thats the one i got, the pic doesnt show a hole either...

mine didnt feel as torn up as sumpfasts looks, felt like it wasnt deteriorated at all...

10-15-2004, 10:31 PM
taking off the old one is a biotch............I just cut mine in half.

Slipping on the new one is ever worse.....lube the $hit out of it...LoL

10-15-2004, 10:41 PM
About to turn over 100k think it's time for a snubby. Do you think it would have been replaced with my new motor?

10-16-2004, 05:03 AM
no... probably now..best to do it with the TB change

10-19-2004, 09:52 AM
tip: before putting the new one on, stick it in the microwave for 15 seconds. Slips right on then.

10-19-2004, 10:13 AM
ha, wanna drive down from indy to boone and help me put it on?

10-19-2004, 01:13 PM
Where is boone? lol

It's not a hard job tho - you can do it without taking the front end off. Just slide it out a little into the service position and you can get it on.

Took me 2 hours.