PDA

View Full Version : i want to install my boost gauge.



derek2079
10-10-2004, 01:32 PM
how do i get the line inside my car. i have been searching for pics all over. i dont know where to bring the line so i can mount it inside my car. help pls

EVIL-AUDI
10-10-2004, 01:52 PM
There are tons of articles and thread on this subject. There is a very big opening underneath the ECU that line can be fed through. Aswell as areas on the passeger side aswel.

derek2079
10-10-2004, 01:57 PM
ok thx. do i need to pop my ecu off?

EVIL-AUDI
10-10-2004, 02:14 PM
You'll need to take tha black casing cover off, you'll be able to see the opening if you then take the ECU bracket off, and look under there.

derek2079
10-10-2004, 02:16 PM
Originally posted by EVIL-AUDI
You'll need to take tha black casing cover off, you'll be able to see the opening if you then take the ECU bracket off, and look under there. ok i will do this now ty

D Piddy
10-10-2004, 02:23 PM
go to www.awe-tuning.com , then go to their boost gauge, then on the left, there's a link to their installation PDF that has great instructions

Audi Skate Snow
10-10-2004, 03:22 PM
There is a hole in the firewall right by the brake resivoir i believe...it has a ruber gasket pop it off and then put the line throw or put a hold in the gasket.

derek2079
10-10-2004, 07:06 PM
i tried for an hour i cant figure this out

TheEZest
10-10-2004, 07:14 PM
AWE's instructions that D Piddy was talking about are awesome. those are what i followed and it made it so easy. problem is...i dont see the instructions on AWE's website where you said it would be D Piddy. if you found it then put a link cus i sure as hell can't.

TheEZest
10-10-2004, 07:17 PM
spoke too soon...i found them. they only appeared when you look at the gauges in the S4 section.

derek, use these....
http://www.awe-tuning.com/media/pdf/ventgauge.pdf

Audi Skate Snow
10-10-2004, 07:29 PM
Hope this helps. Run in through that hole.....there is a ruber gasket you have to either drill a hole in the gasket and run the line throught that or you can do what i did and then tape it off....get under the stering wheel and look for the light comin in...really easy.

http://mediaservice.photoisland.com/auction/Oct/200410105730170998051240.jpg
http://mediaservice.photoisland.com/auction/Oct/200410102239245178206783.jpg
http://mediaservice.photoisland.com/auction/Oct/200410102353955167820290.jpg

hope this works