PDA

View Full Version : need exhaust shop reference - north jersey



wofman
09-23-2008, 10:30 AM
Where to get Magnaflow components installed? Meineke in Denville and Newark have been recommended. Any place else? Looking to get 2.5" catback -- I can get hardware I want to use (except tube/pipe). Where is best place for assured, top quality workmanship?

I've searched AZ and surprised there is not much on here. Would have thought there would be a few obvious shops that Audi folks use. Did I miss something?

wofman

NogaroS4NJ
09-23-2008, 10:38 AM
http://www.elitemotorsnj.com/home.html

Right there dude, does the best work in NJ.

wofman
09-23-2008, 11:06 AM
Totally agree re Sam. Use him for everything and will have him put on downpipes. But being between shops, didn't think this components was job for him. Need lift, no?

UGwagen
09-25-2008, 07:03 PM
the Meineke in Dover does decent work also. They installed a CB on my friend's 545i and they repaired my exhaust on my old car--- the stock pipe after the cat rusted off....

onewicked
09-30-2008, 02:42 PM
I don't know if i am too late, but meineke on RT 22 in mountainside (PEDRO) does excellent work, he does plenty of custon exhausts daily. or you can try AZEVEDO MOTORSPORTS in linden on St George Ave, Diogo only use's magnaflow.

Blitzkrieg989
10-02-2008, 03:54 PM
http://www.elitemotorsnj.com/home.html

Right there dude, does the best work in NJ.

X2 Elite Motors only place!!!!

joeycuccaro
10-02-2008, 07:54 PM
X2 Elite Motors only place!!!!

x3 sami is incredible

Beelzeebub
10-08-2008, 09:01 PM
http://www.elitemotorsnj.com/home.html

Right there dude, does the best work in NJ.

how's the $ impact with them?

wofman
10-09-2008, 07:29 AM
I'm picking up my car from Sam today -- AWE downpipes, Milltek (slightly used). He had to fuss with a welded O2 sensor on old piggies, "salvage" my heat shields, deal with prior slapdash install of catback brackets, even some corrections to what was done, including with Milltek tips, then he cut through the 2000 valence -- so I guess I'm seeing value of his expertise with my installation. I'm sure Midas is cheaper but Sam is fair, not overpriced.