PDA

View Full Version : finally up and running again... what logs do you want?



bernB5
07-12-2008, 02:40 PM
So, finally I swapped in the wiring harness/ecu, made an inlet and fixed me insane coolant leak.. car is running well, although I believe the primary o2 is bad, I got this:
16518- o2 Sensor Circuit No Activity Detected Bank 1 Sensor 1

Wires could be screwed up or the sensor itself could likely be shot, It hasn't been used in 2 years, and before that, it was on the car since 1997 with 120k miles of use...

The car idles at 10:1, so obviously it's either the o2 or the tune...

Under boost it's a bit rich as well, but as far as driveability goes I'm 100% satisfied. Starts up right away, even at 10:1 it idles steady at 950rpms.

What three blocks should I log to get a feel for the timing/af curve and anything else you guys want to see. Boost is around 17psi right now, I know it has fuel so I'm not worried about damaging anything like some previous horror stories we've heard about tapp.

I'll have some pics and vids soon [up]

bassed
07-12-2008, 04:36 PM
03 and 11 are good to start with. You're getting AFR's from a WB if you don't have an EGT you can take a gander at 34 to see temps in *c.

bernB5
07-12-2008, 04:56 PM
yeah, reading from my PLX wideband, no EGT, probably should invest in one though.
It's been about four years since I needed to log anything, between the evo and running 034, I'm outta practice.

Anyway, I'll give those a shot, thanks dude.