View Full Version : lltek rslook bumper install.

05-29-2008, 08:02 PM
i got a rslook bumper but i do not have the mounting hardware or glue.

and i for some reason audizine doesn't have a search link anymore. does any one have any info on how to install it or where to get the mounting hardware?

05-29-2008, 08:05 PM
you know I just went to search, went to click where it normally is and was like wtf? there is no search!! where did it go?.. But besides that, i don't know your answer, someone does though.

05-29-2008, 08:05 PM
off topic already where is the search button???????????

and cant you just use the old bumper support with it??

05-29-2008, 08:16 PM
well yeah but dont i need to glue it? is there a install guide somewhere?

05-29-2008, 08:20 PM
personally, if I was you. I would just use a couple zip ties. But this is coming from someone who takes there bumper off a lot. There is no special glue that I know of, I would just try to use some really strong epoxy of some sort. It is just the cover, it doesn't take much to hold it in place.

05-30-2008, 02:30 AM
This stuff should do the trick

Link (http://cgi.ebay.com/SIKAFLEX-1A-Polyurethane-Elastic-Sealant-Adhesive-lot-5_W0QQitemZ120267475398QQihZ002QQcategoryZ66914QQs sPageNameZWDVWQQrdZ1QQcmdZViewItem)

05-30-2008, 09:11 AM
thanks ill look in to that and when i am done with the bumper i can seal up any leeks.

05-30-2008, 09:52 AM
thanks ill look in to that and when i am done with the bumper i can seal up any leeks.


05-30-2008, 09:57 AM
SEARCH works good right now from HotLanta.

05-30-2008, 09:58 AM
You don't really want to glue the bumer cover on do you? Won't that make removing it a huge PITA? My rieger RS4 front is held on by 3 screws on each side. One of them goes from top of bumper (kinda inside wheel well), up into the sheet metal right by the turn signal. Other two screws (per side) go through the bumper, into the wheel well liner. ALL of these screws are inside the wheel.

Just a thought... yours may be entirely different though...