PDA

View Full Version : Installing stainless steel brake lines



BoxersRule
03-20-2008, 07:44 AM
Hi guys,

I'm going to install stainless steel brake lines this weekend and I have a couple of questions.

I have a one man brake bleeder kit that uses compressed air to pull the fluid out at the caliper that I purchased from HFT anyone used these before? Are the good? crap?

- How do you get the screen out of the brake reservoir to suck the fluid out or, do I even need to do this? The kit has a bottle that you fill with replacement fluid and attach to the top of the reservoir. I have ATE super DOT 4 blue replacement fluid to replace the ATE gold in there now.

- Should I replace a brake line then bleed it? or should I just replace all the lines (2 in the rear) and then bleed the lines?

Any comments, gotchas, etc are greatly apprieciated

pinky
03-20-2008, 07:48 AM
replace all lines then bleed the entire system

the screen comes out.. just pops out.. i think i used needle nose pliers to grab and pull