HID fog install

[hyethug000]

For those of you who have completed this mod, do I need to remove the bumper or can i just do it without removing thebumper. I have a non s-line bumper...

TIA

[evilgabbie]

you should be able to take the fog out without removing bumper, then reach from the engine bay for wires... easier with a jack or lift of course

[LAS]

you can try with the bumper on. but personally i'd remove the bumper, you run the risk of bumping around the hid bulb, especially those fragile rebased ones.

good luck.

[Sharkfin]

if you do this please post how you did it and if it was hard for you....thinking about doing the same

[BenGieCruz]

i tried w/o removing the bumper and had no success....[down]

[Sharkfin]

ahh me too, oh well looks like taking off the bumper is a must

[peta8368]

someone correct me if i'm wrong, but i remember that the s-line bumpers (and i guess the standard bumper for 08+) have removeable covers for the fog light. Once you remove those, you should be able to see screws holding the fog light.

However, for the non-sline pre-08, you either have to have really thin/flexible arms, or you have to take off the bumper


Peter

[LAS]

^^^correct.

[AudiWxGuy]

Are the yellow fogs on ECS, the same as an HID Fog Kit? If not, where could one find an HID fog kit for our cars?

[Buttafuoco]

all you need is a conversion kit from vvme, visionbulbs,...etc. with h11 bulbs

i would like to do this too, but i'm worried about bulb-out warnings and flickering fog lights since there's no way to recode the fogs.

[LAS]

Are the yellow fogs on ECS, the same as an HID Fog Kit? If not, where could one find an HID fog kit for our cars?

if you provide a link, that would help...

[AudiWxGuy]

http://www.ecstuning.com/stage/edpd/pagebuild_v2.cgi?make=Audi&engine=2.0T&model=B7%20A4&submodel=Quattro&category=Lighting&subcategory=Fogs

[LAS]

these are just normal halogen bulbs.
http://www.ecstuning.com/stage/images/dis/7411/600/7411.jpg

[hyethug000]

well i'm going to try it out tonight, I'll let you guys know what happens.

[leozip]

So, these will fit the for the fogs?

[AudiWxGuy]

Once again...where can we find these kits?

[pyrobecks]

Once again...where can we find these kits?

x2... but I'm more interested in Projector Housings for these...?

[LAS]

i don't think they make projector fogs specifically for the b7. it seems our reflector fogs housings are adequate enough were it will not blind others.

you can google h11 h.i.d./xenon conversion kit

or search:
http://www.audizine.com/forum/showthread.php?t=180025

[Sharkfin]

someone let us know if they try it, id like to upgrade too

[LAS]

once again...search is your friend:

http://www.audizine.com/forum/showthread.php?t=74008&highlight=hid+fogs

[Quattro]

to install hid on non sline would be nearly impossible without removing bumper. When I tired I didnt have room.

I would recommend removing front bumper. Any really kit would fit as long as its h11 hid.