Need someone to measure placement of rear 'Rings' emblem for me

[ENDEE666]

Hey guys. Had my trung repainted due to some scratches while my car was at the body shop from the minor fender-bender I had last week. Had them spray the trunk lid & that lame silver strip at the bottom of it while they were at it. (The strip made an amazing difference too, btw. I never liked that thing, and now that it matches the black of the rest of the car it looks great!)

Now I need to re-apply a brand new 'Rings' logo on my trunk. I need someone to measure out proper placement for me so I can get it to oem placement. Left to right I can handle, its up to bottom I need you guys to help out. I was thinking to use the license plate trim plastic as a guide. the part with the rear fogs, etc.

So lets use where the trunk begins above that plastic insert as a reference point. How far up from there is the bottom of the rings?

Thanks fellas!!

[CALL AAA]

Ok, disregard my reply on AW. I'll measure in the morning, if it's not 490 degrees in my garage.

[ENDEE666]

It is a sedan tho

[CALL AAA]

I measured it our on my car, and it's 3-1/4 inches from the underside of the top of the license plate housing to the bottom of the rings. I don't have a decent picture of the back end of mine, so I used this one instead. (If I'm not mistaken, the rings on the RS6 are crooked, just like my picture)
http://i4.photobucket.com/albums/y123/CALLAAA/ringsplacement.jpg

Let's see some pics of the Z!

[ENDEE666]

Thanks for the help man. Will use both measures for reference to be sure. And I am prob going to take a nice pic of both of my cars for my sig once I clean the Z. Has a ton of brake dust on it right now from some 'spirited driving' earlier this week... Ceramic brakes make a mess....