View Full Version : Quick how to ?

08-26-2007, 02:33 PM
anyone know how to remove the plastic on the doors that is around the lower door handle with the window switches, and the upper door handle with the doorlock switch?


08-26-2007, 05:36 PM
bump this...

I really likes a4fann's job on his interior with the ultrasuede and i want to wrap those parts of the door since theyve been scuffed up a bit over the years...

08-26-2007, 08:09 PM
you'll probably have to take the entire panel off, but im not sure. if you do, this is how:

08-26-2007, 08:28 PM
there is a rear facing screw...take that out. Then use your finges and pull the plastic downward. Use fingers on both hands and push forward on the door on the trim piece and pull down at the same time. This will gain access to 2 screws. Then take the black screws off the top of the door card. There is one towards the front and one towards the rear. After that you should be Use your camera phone and take pics of the connectors so you know where they go later. Pull the connectors off and remove the door card. You can figure out the rest from there. I believe there is one screw holding on the door handle trim then just pull it out.

08-26-2007, 08:37 PM
thankyou guys

.Mad Hatter.
08-26-2007, 09:12 PM
heres how to get the upper part anf door card off, i just took them off to paint my handles....


08-27-2007, 10:06 AM
blah my link was supposed to be the same as yours, i dunno what i did there