View Full Version : symphony I HU/amp wires?

08-26-2007, 01:21 PM
Have stock symphony one HU, and was trying to put in some subs.. What wires do I need to tap into on the stock amp? I found a tut but it is for the symphony II and the wire harness is a little different.. can someone point me in a good direction or tell me? Thanks.

08-26-2007, 05:55 PM
bump.. anyone?

08-26-2007, 06:38 PM
If I recall correctly, there's a signal wire going to the rear amp (attached to the rear driver's speaker) - you can tap in there for signal for your amps.

08-26-2007, 07:08 PM
Ok, but does anyone have a diagram or something that can show me what wire is to what on the harness? I have no idea what wire is what speaker ect.. the tut on a4mod is for symphony II which apparently has a different setup then the symphony I.. I just need to know what wires are what back there.

08-26-2007, 07:16 PM
Try this: