PDA

View Full Version : blowing damn hoses!



europshhrc279
06-13-2007, 08:55 PM
today wasnt a good day...im getting to my friends house and im driving not so fast but enough that i was in boost..well i had noticed the stock turbo outlet that i connected to my aluminum piping had moved a bit more then usual so i had been worried.. the case is that it blew off and i had to disconnect the MAF to drive it home..i connected it again and clamped my t-bolt on there tight..i drove to a friends house and back and when i got home the damn thing was nearly almost off again..tomorow morning i gotta wake up early and fix it..i hate being scared to get into boost! so can anyone help me out with this..right now how i have the stock turbo outlet hose connected to the aluminum piping is like this...

http://i13.photobucket.com/albums/a251/calle6289/Step1.jpg
http://i13.photobucket.com/albums/a251/calle6289/Step2.jpg
http://i13.photobucket.com/albums/a251/calle6289/Step3.jpg
http://i13.photobucket.com/albums/a251/calle6289/Step4.jpg

i need to make this thing stay on! helllpp me out guys!

Starting
06-13-2007, 09:12 PM
sanding the pipe a bit with some low grit sand paper should give the hose a better bite. Either that or have someone weld a bead around the end.

europshhrc279
06-13-2007, 09:41 PM
thnx guess i could try that but i need more ideas

AudiSport12
06-14-2007, 02:08 PM
i set mine up the exact same way you did it. i would get into boost and it would just pop offfrom the turbo outlet hose. i took it to work and had them weld little beads going all the way around the little 2 inch pipe so the when i clamp on top of it, it wont go anywhere. it hasnt popped off since.

and i tried the low grit sandpaper thing before and it lasted no longer than a few hours before it popped off.

so take it to a muffler shop or something and have them put beads around the pipe


edit**: you could try somehow bending the lip of the small pipe so the clamp wont slip off. but then it may be hard to get the turbo outlet hose on

mike-2ptzero
06-14-2007, 03:04 PM
Without a bead on the pipe the hose is never going to stay on since there is nothing for the hose and clamp to grip onto. Other problem is that the oil vapor from the crank case gets into the IC pipe and is going to find its way between that hose and pipe.

europshhrc279
06-14-2007, 04:04 PM
wow thnx guys that sounds like an awesome idea..right now i have it on tight and it hasnt moved but its still something im worried about..so i think tomorow morning before work ill wake up and take it a second so they can weld up a couple beads to keep the clamp or rubbers from sliding..

Burntaudi
06-14-2007, 04:18 PM
Try some hairspray at the connections. Once it drys it's like glue.