PDA

View Full Version : Help? Trying to remove woodgrain trim.



Shifty
04-05-2007, 05:30 AM
I'm trying to do this without breaking anything. Just want to get this stuff off and paint it. It doesn't seem to just pry out like most trim does. [wrench]

I searched. Pre-emptive thanks.

d_maniac
04-05-2007, 07:54 AM
i used this guide when i put in s4 wood in my 1.8

sean1.8t
04-05-2007, 08:09 AM
^HAHA

this should help you. FYI, it aint no easy task

http://www.rnsdesign.com/estore/install_guide.htm (http://www.rnsdesign.com/estore/install_guide.htm)

Ewok_Fetus
04-05-2007, 08:27 AM
Rob, if you ever need any help on that thing, just ask!! I should also have your shift boot made in a week or two. I may need to use your old one as a template as the 99.5+ are different from the 98's I believe!

Shifty
04-05-2007, 04:21 PM
Holy crap that sucks! Thanks guys.

Ewok, have you ever had your trim out?

Ewok_Fetus
04-05-2007, 04:31 PM
Just the doors... I haven't had the dash out yet. Was going to get the RS4 carbon fiber trim, but I don't have $5,000,462,573,754,346,234 to pull out of my ass for all of that...

d_maniac
04-05-2007, 05:32 PM
i did the whole trim on my car and its not that hard just the two MIDDLE clips in the middle of the dash.