View Full Version : Prepping GTRS

03-24-2007, 11:09 AM
Should I just run some synthetic oil through it before I start it up? Anything special you guys recommend? About to pull my k03 out, only thing holding me back is that allen hold in bolt. I read on a write up its a 6mm? I can't get a 6mm to fit, and a 5mm is to small. IIRC i tried a 5.5mm and it was to small as well.

03-24-2007, 11:12 AM
Lightly tap the 6mm in, there may be some corrosion in the way keeping it from going in by hand....

03-24-2007, 02:01 PM
yep, "taaap it in, tap tap tap..."

it is a 6mm