Audizine - An Automotive Enthusiast Community

Results 1 to 27 of 27

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Established Member Two Rings
    Join Date
    Dec 03 2016
    AZ Member #
    387409
    Location
    nowhere

    Is there an alternate and safe jack point for the front instead of the pinch welding?

    I'm prepping for my first brake job and wanted to avoid effing up the underside of the car. I hated jacking up my B7 from the pinch weld and even placing the jack stand on that point. As soon as I let the weight down, it cut right through the paint and rubber like compound. Then it's exposed metal and hated looking it every time I went underneath.

    Also:

    Any recommendation on a good set of ramps? I was thinking of this route but am kinda hesitant.; had an nissan sentra when I was a kid and almost tipped the ramps forward - never forget that.
    -and-
    Does anyone remember the actual OE makers of the stock front pads for the B8? You may have seen it stamped on the old pads.
    Last edited by flowhigh; 12-07-2017 at 02:23 AM.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


    © 2001-2017 Audizine, Audizine.com, and Driverzines.com
    Audizine is an independently owned and operated automotive enthusiast community and news website.
    Audi and the Audi logo(s) are copyright/trademark Audi AG. Audizine is not endorsed by or affiliated with Audi AG.