i got a couple fault codes, mind heplping me find the problem??

[arab06]

p1136


p1606


p1138

[KaoticS4]

P1136 and p1138 are lean codes, check For vac leaks, MAF, fuel filter,etc.

No clue what p1606 is, did you try Google?

[arab06]

so vac leaks can be causing both or just one?

i havent, ill give it a try right now

[temagnus2004]

Vacuum leaks would cause P1136 and P1138 codes. Car has a boost gauge ? If so, check where you "Teed" off the vacuum hose. This would also affect the FPR.
Get Ross-tech cable and also test precat O2 sensors. Might want to pull MAF out and see if its dirty.

[zadeluca]

P1606 is "Rough Road Spec Engine Torque ABS-ECU Electrical Malfunction"

[Scotty@Advanced]

P1606 is "Rough Road Spec Engine Torque ABS-ECU Electrical Malfunction"

Could be classic ABS module failure.. But I've not seen that one.

[MCsquared]

P1606 is "Rough Road Spec Engine Torque ABS-ECU Electrical Malfunction"

I've seen that one with failed modules before

[arab06]

Vacuum leaks would cause P1136 and P1138 codes. Car has a boost gauge ? If so, check where you "Teed" off the vacuum hose. This would also affect the FPR.
Get Ross-tech cable and also test precat O2 sensors. Might want to pull MAF out and see if its dirty.

where would the maf sensorbe located at??

[arab06]

I've seen that one with failed modules before

so basically get the module rebuilt?

[arab06]

i got my check engine light to turn off. those hoses were ripped! thanks for the help guys!! now i just need to find out whats wrong with the other one!

[temagnus2004]

Maf located on left side of engine after air filter and before "y" pipe. There are two torx screws holding it in place

[arab06]

is it for sure that?

[KaoticS4]

is it for sure that?

No the lean codes could be either one of the things mentioned above, you asked where the MAF sensor was and he answered. If you found ripped hoses and you fixed them and CEL went off you found the source of your p1136 and p1138.

Or if your asking if what temagnus2004 is describing is for sure the MAF sensor then the answer is yes lol.

[arab06]

but see now my check engine light is off, but my abs light is on and my brake light flashes

[zadeluca]

your ABS module needs to be rebuilt. its a fairly common problem with these cars

[arab06]

how much does it cost? do you know?

[zadeluca]

here is one vendor that will do it: http://cheap-abs.com/index.html

im sure if you search you can find others