Lowered 3.2 V6 owners... help me out

[coletrain]

Does anyone on the forum have lowering springs on their 3.2 that are the same as the one for the 2.0s? I have heard mixed opinions. From what I understand is that we need springs that have a different spring rate because of the added weight. I have a set ordered but they are the set intended for the 2.0. Just was curious if anyone on here had any insight on this... thanks in advance.

[A4_Ti]

Interesting... never even considered this, I assumed factory springs were the same in the 2.0 and the 3.2

[Charles.waite]

Theyre different between the 2.0t, 3.2 and S4. Basically because of the weight differences. Same deal with the b6 platform.

[mtosofsky]

i wouldnt use them. They will sag more, especially in the front.

[ignus99]

Quattro MT 2.0T = 1554kg
Quattro Tip 3.2 = 1690kg
Quattro MT 3.2 = 1659kg

A weight difference of over 100kg will sag the front end.
Long story short - yes, a different spring rating would definitely be needed. Silver lining is - although it is 100kg, its only about 7% heavier... so I would say an additional 7% sag.

Which springs did you get? Whats the lowering amount? For a rough estimate of how much it will sag, add 7% to what they say.

These are all VERY rough estimates tho... I cannot comment on the performance losses from using a squishier spring than designed.

[coletrain]

http://www.ecstuning.com/Audi-B7_A4-...prings/ES2023/ disregard thread lol. There was some confusion but the springs I have coming say they are for the V6's