Just finished putting in S4 seats in my prefacelift A4. The power works so im good there. The question I have is has anybody been able to get the seat airbags to work? The connector on the car is 2 wire and on the seat its 3 wire? All the seat swap threads I seem to find is about the work needed to install the thread serts and get the power to work.
Results 1 to 5 of 5
Thread: Seat Airbag Connetor/Wiring
-
06-25-2011 09:12 AM #1Active Member Two Rings
- Join Date
- Jan 17 2008
- AZ Member #
- 24244
- My Garage
- 1987 Conquest TSi, 2002 Golf, 1998 A4 Quattro
- Location
- Right Behind You
-
06-27-2011 07:36 AM #2Active Member Two Rings
- Join Date
- Jan 17 2008
- AZ Member #
- 24244
- My Garage
- 1987 Conquest TSi, 2002 Golf, 1998 A4 Quattro
- Location
- Right Behind You
So nobody has done this??? All resistored
-
08-07-2011 08:47 AM #3Active Member Two Rings
- Join Date
- Mar 02 2010
- AZ Member #
- 55405
- Location
- Richmond/VA/USA
I just swapped in prefacelift seats in my 1.8t (mine were torn) and it has a 2 wire connector my car has 3. I will be figuring out the wiring this week and post it up.
-
08-07-2011 02:43 PM #4Active Member Two Rings
- Join Date
- Jan 17 2008
- AZ Member #
- 24244
- My Garage
- 1987 Conquest TSi, 2002 Golf, 1998 A4 Quattro
- Location
- Right Behind You
I ended up putting in resistors. Let me know what you work out
-
09-03-2011 03:04 PM #5Senior Member Three Rings
- Join Date
- Dec 09 2008
- AZ Member #
- 36158
- My Garage
- A tricycle
- Location
- Nofolk VA (Its Hood Here)
Yea, I found a wiring diagram and did it. It was quite a few years ago. Sorry I couldn't be any more informal then telling you its doable.Put Werk Here[/SIZE]
Reply With Quote
Posting Permissions
|
|
||||
|
© 2001-2012 Audizine, Audizine.com, and Driverzines.com
Audizine is an independently owned and operated automotive enthusiast community and news website. Audi and the Audi logo(s) are copyright/trademark Audi AG. Audizine is not endorsed by or affiliated with Audi AG. |
 |
|||
Bookmarks