http://www.audizine.com/forum/ Discussion Forum relating to the B5 S4 and RS 4 (1998-2002). Sponsored by Advanced Automotion. en Sat, 18 May 2013 15:20:23 GMT vBulletin 60 http://www.audizine.com/forum/images/misc/rss.png http://www.audizine.com/forum/ http://www.audizine.com/forum/showthread.php/541156-Trying-to-get-a-feeler?goto=newpost Sat, 18 May 2013 15:15:46 GMT Ok guys im thinking about selling my apr dps and awe exhaust when I get done with my tour in afghan... Ok guys im thinking about selling my apr dps and awe exhaust when I get done with my tour in afghan I was just trying to see what you guys think they would be worth willing to sell separately as well just trying to get opinions cause I'm going to go with three inch dps and 3.5 single exhaust ]]> B5 S4/RS4 Zunitsice14 http://www.audizine.com/forum/showthread.php/541156-Trying-to-get-a-feeler http://www.audizine.com/forum/showthread.php/541154-Another-Wheel-and-tire-question-sorry?goto=newpost Sat, 18 May 2013 15:08:27 GMT Searched, can't really find what I am looking for.

looking to buy VMR V708 RS4 Reps 18x8.5 all around. what tire size should I use? and the bolts?











Thanks ]]> B5 S4/RS4 B72.0tsline http://www.audizine.com/forum/showthread.php/541154-Another-Wheel-and-tire-question-sorry http://www.audizine.com/forum/showthread.php/541141-A-Chronicle-Of-My-2000-S4?goto=newpost Sat, 18 May 2013 11:13:27 GMT Finally have decided I should start a thread for the S4, bought the car back in May 2011 and at the... Finally have decided I should start a thread for the S4, bought the car back in May 2011 and at the time it had been sitting for a little and I wanted to bring it back to life. boy did I not realize what I was getting myself involved with at the time. [:)]

my future s4 sitting in DxCs boneyard ]]> B5 S4/RS4 Cartells http://www.audizine.com/forum/showthread.php/541141-A-Chronicle-Of-My-2000-S4 http://www.audizine.com/forum/showthread.php/541129-Fuel-Guage-problem?goto=newpost Sat, 18 May 2013 06:07:02 GMT For some reason my fuel gauge will never read FULL. It always stops at 3/4 of tank. I have replaced... For some reason my fuel gauge will never read FULL. It always stops at 3/4 of tank. I have replaced the fuel sender with a brand new one but that did not fix it. I have searched but everything I find says to replace fuel sender. Are there any other ideas? ]]> B5 S4/RS4 corneliusmixon http://www.audizine.com/forum/showthread.php/541129-Fuel-Guage-problem http://www.audizine.com/forum/showthread.php/541125-vinyl-wrapping?goto=newpost Sat, 18 May 2013 05:34:28 GMT Does anybody have any experience with vinyl wrapping their whole car? How well does it hold up over... Does anybody have any experience with vinyl wrapping their whole car? How well does it hold up over time and to weather? Does it look good if done professionally? ]]> B5 S4/RS4 z00lander http://www.audizine.com/forum/showthread.php/541125-vinyl-wrapping http://www.audizine.com/forum/showthread.php/541097-So-something-in-the-clutch-area-took-a-dump-today?goto=newpost Fri, 17 May 2013 23:54:54 GMT Car had 109k on it so, it was expected to happen eventually. I apologize if these questions have... Car had 109k on it so, it was expected to happen eventually. I apologize if these questions have been asked already.

What are your opinions on the SPEC stage 2 clutch/ PP?

Do I need a new flywheel? I have not replaced them in the past and gotten away with it. I know they tend to separate on the B6 S4's and was curious as to whether this has the same problem. Also, is resurfacing out of the question?

Again, sorry if this has been asked 1000 times. I'd hate to be that guy.

All information appreciated. Thanks ]]> B5 S4/RS4 Imola34 http://www.audizine.com/forum/showthread.php/541097-So-something-in-the-clutch-area-took-a-dump-today http://www.audizine.com/forum/showthread.php/541077-Lip-Safe-Mode-Volume-7?goto=newpost Fri, 17 May 2013 21:30:29 GMT Okay guys so im back in limp mode...for which seems like the 15th time. Pulled codes, P1296( Error... Okay guys so im back in limp mode...for which seems like the 15th time. Pulled codes, P1296( Error in mapped cooling system) and P1557( Charge Pressure Control: positive deviation)

Now some things seem obvious to check. like to coolant temp sensor, and the DVs. But i replaced the CTS 2 months ago when i had my no start issue, and i preplaced 1 DV around new years. So what else is there to check? or any common problems? if i have time tmmr I plan on pressure testing the DVs to see whats. kinda PSI they hold. ]]> B5 S4/RS4 blkNJ a4 http://www.audizine.com/forum/showthread.php/541077-Lip-Safe-Mode-Volume-7 http://www.audizine.com/forum/showthread.php/541070-B5-S4-New-Stereo-Heads-Up-Display-question?goto=newpost Fri, 17 May 2013 20:57:58 GMT So i want to buy a new stereo for my s4, im pretty sure im going to get the pioneer appradio. The... So i want to buy a new stereo for my s4, im pretty sure im going to get the pioneer appradio. The only thing i was wondering was what happenes to the Heads Up Display which ussaly shows the station the cars radio is on? will that continue to work or will it become blank? ]]> B5 S4/RS4 big_jerm http://www.audizine.com/forum/showthread.php/541070-B5-S4-New-Stereo-Heads-Up-Display-question http://www.audizine.com/forum/showthread.php/541068-Raising-the-motor-for-ground-clearance?goto=newpost Fri, 17 May 2013 20:49:28 GMT I want to know your thoughts on this:

I have clearance issues with my 3" downpipes. They were custom fabbed for the previous owner at a local shop. They look nice but hang down about 1/2"-3/4" or so too low. Thus I bang my cats and V-bands on speed bumps unless I have the car up pretty high (fender to ground in the 25.75 in range).

I am changing my motor and trans mounts and want to know what you guys think of putting in some custom washers under the motor mounts to get maybe 1/4"-3/8" clearance. Do you think this will mess up the prop-shaft angles or anything? I don't think I can get the full 1/2" but maybe a bit more will make things scrape a little less.

I have made up some 2 3/4" wide washers with half inch holes that are about 3/16" tall. I was going to start with 2 and see. From what I can see it shouldn't be an issue.

Thoughts?

Jeff ]]> B5 S4/RS4 jeffreyk http://www.audizine.com/forum/showthread.php/541068-Raising-the-motor-for-ground-clearance http://www.audizine.com/forum/showthread.php/541032-Short-distance-pulling?goto=newpost Fri, 17 May 2013 18:01:48 GMT So I'm taking my imola to my dads place soon to start the build. What are you guys doing for short distance pulls? Car doesn't run and a tow truck is overkill. It has an aftermarket rs4 bumper, brand unknown. Is there a tow point I don't know about? ]]> B5 S4/RS4 1gcrazy http://www.audizine.com/forum/showthread.php/541032-Short-distance-pulling http://www.audizine.com/forum/showthread.php/541001-Clicking-from-brakes?goto=newpost Fri, 17 May 2013 14:09:47 GMT So to start off, I have stop tech's st40 355mm. So my front rotors are warped. I believe it could only be the passenger side but not 100% sure. So when I brake I get this horrible shaking. Getting them resurfaced this weekend. But I've noticed now that I can have my windows down, is that there is a clicking as I brake. Its an ugly sounding clicking. As I pull up to a stop sign you can hear it if you're walking down the street. It goes with the rotation of the wheel.

Im not sure what this could be. Any ideas? ]]> B5 S4/RS4 AuDi S4B5 http://www.audizine.com/forum/showthread.php/541001-Clicking-from-brakes http://www.audizine.com/forum/showthread.php/540993-What-are-the-spec-for-these-wheels?goto=newpost Fri, 17 May 2013 13:03:05 GMT Hi guys, Just trying to find the specs for the Rotiform wheels fitted to this RS4. Any help... Hi guys,

Just trying to find the specs for the Rotiform wheels fitted to this RS4.

Any help would be greatly appreciated.



]]> B5 S4/RS4 weekend-warrior http://www.audizine.com/forum/showthread.php/540993-What-are-the-spec-for-these-wheels http://www.audizine.com/forum/showthread.php/540975-b8-shifter-to-my-b5-s4-tip?goto=newpost Fri, 17 May 2013 05:04:57 GMT i was wondering if any of you guys have tried to fit the b8 s4 or stronic to the b5 s4 or a4 it is... i was wondering if any of you guys have tried to fit the b8 s4 or stronic to the b5 s4 or a4 it is this knob/boot

http://www.ebay.com/itm/Audi-S4-B8-o...4a49ef&vxp=mtr

thank you for any help ]]> B5 S4/RS4 audiaustin94 http://www.audizine.com/forum/showthread.php/540975-b8-shifter-to-my-b5-s4-tip http://www.audizine.com/forum/showthread.php/540974-For-all-you-VR6-s4-guys?goto=newpost Fri, 17 May 2013 05:04:27 GMT billet oil filter housing for spin-on filter and direct clean oil turbo feed outlet... Image:... billet oil filter housing for spin-on filter and direct clean oil turbo feed outlet...





]]> B5 S4/RS4 boostinallday http://www.audizine.com/forum/showthread.php/540974-For-all-you-VR6-s4-guys http://www.audizine.com/forum/showthread.php/540951-Brake-Line-Part-Number?goto=newpost Fri, 17 May 2013 01:47:46 GMT Okay, so I've been trying to get this brake line through a part out but have had 0 success. Just want to confirm that this part number is correct. 8E1614706J

It should be the hard line that comes off the rear of the master cylinder and runs to the underside of the ABS module. ETKA shows it running to the top of the ABS module. Can anyone confirm this and secondly, does anyone have one from a part out that they can sell?

Thanks for any help.

http://www.ecstuning.com/Search/8e1614706j/ES441622/ ]]> B5 S4/RS4 Dutchsider http://www.audizine.com/forum/showthread.php/540951-Brake-Line-Part-Number