PDA

View Full Version : "Heather"



Kurzer
03-31-2005, 01:00 PM
Work in progress. I lost all my pics so I'll need to go take some more soon.

1996 A4 Quattro Manual
Color: LZ6U Emerald Green
VIN# WAUEA88DXTA002083
Rated BHP: 179
Rateg Lb.Ft. Torque: 190
Fuel Used: Premium +Octane Boosters

*indicates NEW within the last 6 months

Interior:
Clarion 745 MP3 deck
Clarion 1200watt 5Ch amp
Stock Bose 8 speaker surround
Kicker Solo Baric 12" sub in SubZero sealed box
Valentine1
Black Alcantara shift boot w/ Ecru stitching
Audi Sport black leather sift knob
COMING SOON - Uniden Bearcat trunk tracking scanner install

Exterior:
Valeo halogen E-Codes
Fondmetal 6600's 18x8 w/235/45 18 Hankook Ventus rubber
H&R sport springs w/Bilstein sport (non-grooved) struts
Rolled front fenders
ECS Tuning A8 brake kit (12.3" cross-drilled/slotted discs, TT carriers, Stock calipers, Pagid pads)
Braided steel brake lines
Magnaflow high-flow CAT's
Custom 2.50" exhaust piping
Magnaflow high-flow inline mufflers (x2)
Magnaflow 14833 Street series end muffler (Soon to be a 14830)

Fixed: (I add this because it's been the bulk of my spending thus far)
Radiator
Radiator return hose
Temp sensor
Thermostat*
Engine wiring harness*
Power steering pump*
Water pump*
Right tie rod end
Left tie rod end
Left lower control arm
Right CV boot (outer)
Left CV boot (Inner/Outer)
Right front axle*
Left front axle*
Left front ABS sensor
Right rear wheel hub
Left rear wheel hub
Misc vacuum lines

Engine:
Matrix StageII clutch
K&N drop-in
AWE Drive Train Stabilizer*
ECS Snub Mount*
More to come now that I'm done (I hope) fixing the car...

idrivemyself
04-01-2005, 01:01 PM
you kill me tim, naming the car after your wife. [drive]

how'd it go at matrix last week btw?

Kurzer
04-04-2005, 10:03 AM
Went GREAT!!!! I think it was the engine harness screwing everything up. The car is running much smoother now, I mean... she still sounds pissed off but not nearly as often. Matrix ran into some issues with the heater core but made it work, so now that's on my list of things to replace. Of course, if I can get the A3... everything in the A4 is getting stripped and we get to weld!! [wrench] work it baby!!! The chance of that is slim, so I'm looking through the Bentley on what all is involved with replacing the heater core.

robots_are_neon
02-05-2006, 04:44 AM
what no pix?!?