EHUnlucky7x9
05-07-2011, 10:42 PM
Hi all,
I've been through so many different Audi forums, but have not found my answer. I purchased the R8 style L.E.D. Projector Headlights in a black housing. When I took apart my bumper and removed the headlight, I found my wire harness to have only 6 pins out of the available 10. The new L.E.D. headlights have 10 pins on them.
http://www.audizine.com/gallery/data/500/PINOUT-AUA4B7-S5B.jpg
I found a B7 headlight harness layout and it says that pins 1,2,3 are suppose to be the leveling motor wires. The only pins available on my car's harness is pins 5,6,7,8,9,10.
I have a 2008 A4 Quattro S-Line. The OEM headlights are not projector...nor bi-xenon. Standard H7 bulbs. Below is the picture of the headlight I'm installing. I installed them and the low beam works, the high beam works, and the turn signals work....but no power to the L.E.D. lights.
Can anyone help me figure this out? All the forums I've read said that everyone has a 10-pin connector for standard halogens and 14-pins for the bi-xenon. Why is it that my car has only 6-pins? The holes that pins 1,2,and 3 would go into have only a rubber stop to them with no pins.
http://images.channeladvisor.com/Sell/SSProfiles/33000297/Images/4/PRO-YD-AA405-DRL-BK.gif
I've been through so many different Audi forums, but have not found my answer. I purchased the R8 style L.E.D. Projector Headlights in a black housing. When I took apart my bumper and removed the headlight, I found my wire harness to have only 6 pins out of the available 10. The new L.E.D. headlights have 10 pins on them.
http://www.audizine.com/gallery/data/500/PINOUT-AUA4B7-S5B.jpg
I found a B7 headlight harness layout and it says that pins 1,2,3 are suppose to be the leveling motor wires. The only pins available on my car's harness is pins 5,6,7,8,9,10.
I have a 2008 A4 Quattro S-Line. The OEM headlights are not projector...nor bi-xenon. Standard H7 bulbs. Below is the picture of the headlight I'm installing. I installed them and the low beam works, the high beam works, and the turn signals work....but no power to the L.E.D. lights.
Can anyone help me figure this out? All the forums I've read said that everyone has a 10-pin connector for standard halogens and 14-pins for the bi-xenon. Why is it that my car has only 6-pins? The holes that pins 1,2,and 3 would go into have only a rubber stop to them with no pins.
http://images.channeladvisor.com/Sell/SSProfiles/33000297/Images/4/PRO-YD-AA405-DRL-BK.gif