PDA

View Full Version : Winston@podi.ca resistor mod



Maverick
11-04-2008, 02:54 PM
Winston, I am calling you out so you can make some resistors for the LED city lights that go into our Ecode housings.

whoever is interest in this mod please chime in

winston@podi.ca
11-04-2008, 04:39 PM
Well get at least 8 people and I'll go get the parts to make them.

Price is $20 shipped for a pair of the regulators.

SLC_S4
11-04-2008, 04:53 PM
Why do you need resistors if you use LED city lights? I have LED city lights and have no problems.
Unless it's different for other models

Maverick
11-04-2008, 05:12 PM
^^^^ you are lucky then

many people have LED city lights burn out or blink

simona
11-04-2008, 09:42 PM
i am in.

ABanT
11-04-2008, 10:26 PM
This sounds good. Any chance they would work for the DRL as well?

SeKKeY
11-04-2008, 11:43 PM
im in if you can find some good LEDs too winston

p1nk50ck
11-05-2008, 12:24 AM
what's all this about?

Maverick
11-05-2008, 12:39 PM
^^^ do a search and look for a thread started by Winston

winston@podi.ca
11-16-2008, 06:51 PM
Due to so many people asking for me to make the regulators I will go buy the parts needed and make a small run of them.

A pair of them will be $20 shipped.

Click here to buy a pair of regulators for $20 shipped! (https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=1208954)

simona
01-05-2009, 06:34 PM
paid back in 12/22/08, no response of any sort yet.

winston@podi.ca
01-05-2009, 06:42 PM
I've been real busy and haven't had the time to sit down and make them.

I apologize for the delay but if you find the delay unacceptable then let me know and I will refund your money.

simona
01-05-2009, 08:09 PM
thanks for the update

winston@podi.ca
02-03-2009, 03:22 AM
I have to apologize to everyone and announce that I am unable to make the regulators.

I have refunded all monies received to those who placed an order.

manguyen
02-04-2009, 01:46 PM
Why were you unable to make the regulators? I'm willing to make them for people if I just have the circuit diagram.

winston@podi.ca
02-04-2009, 02:26 PM
Due to health and stress issues I have right now I been advised not to take on any projects of such a nature.

I have posted up in the original regulator thread all the parts that you need and if you look at the pictures of my regulators you can figure out the circuit diagram. It's not rocket science.

The hardest part was making the small circuit board to solder all of the components onto.