PDA

View Full Version : Need help!



shaahid
04-16-2007, 08:01 PM
So I basically followed NSXJR how-to for my b5 a4 install. However, when I got to the part about switching 2 pins to CAN H and CAN L on the vehicle harness (not the one behind the instrument cluster, the one that plugs into the rns-e) I noticed that there were two twisted wires already going to pin 7 and 12... does this mean the CAN wires are already there and that I don't have to change anything? I connected the RNS-e just to check and the GPS is getting 6 sattelites but the only problem is the rns-e doesn't light up.

I hope all that made sense.