|
|
|
2000 Rs6 Turbos, Rods, and Valve springs
|
|
|
|
|
Quantity
|
Views
|
Date Posted
|
|
1
|
6861
|
Tue June 26, 2012
|
|
|
|
|
Asking Price
|
Condition
|
Distance from you
|
|
SOLD! ($17,000.00)
|
Great
|
|
|
|
|
|
|
Description:
|
History: Car was purchased by previous owner brand new. All stage 3 and motor build work done at TyrolSport at 68,000 miles. I have electronic receipts for motor build. You can contact Mike at Tyrol to get confirmation of build.
I HAVE A FOLDER OF MAINT GOING BACK 5 YEARS.
Recent Maintenance:
Timing belt and water pump was done in Dec. 2010.
In August, I Changed 4 coils, spark plugs, and installed ARD bi-pipe.
In JAN,
I changed all clamps to stronger Clampco T-Bolt style clamps. Around 18 or 20 changed. With exception to the two clamps in the TBB.
Turbine couplers changed.
All smaller clamps changed to bolt clamps.
All vacuum lines changed along with the one time use clamps to stronger version.
Manifold to brake booster braided line changed(this was loose and ended up being the boost issue).
Motor mounts replaced.
RS6 turbo to down pipe gasket replaced.
Intake manifold gasket replaced.
Blue Samco TBB installed. (The older samco TBB looked a little worn)
NAV unit replaced with brand new Symphony 2 from ECS.
Perfect compression on each cylinder, and no more than 2% leakage on each cylinder shown after a leak down test.
This is the 3rd stage S4 Ive owned over the years and by far the quickest one.
Price: 17000
Mileage: 82,2xx
Dyno Numbers: 432 awhp 456 awtq on mustang dyno. Have dyno sheets.
Dyno was done on 7/31/08 in 90 degree weather with very high humidity. Numbers are at least 20 points lower. I'm sure everyone here knows mustang dynos read lower than dynojets(around 20-30). Most people like to post dynojet numbers then compare to mustang dyno numbers.
Engine:
EPL Rs6 Turbos
Vast stage 3 Fueling kit 60lbs and 85mm aluminum housing
Tuned at EPL
ER Inter coolers
AWE downpipes
Miltek 3" exhaust
ARD bi-pipe pre-tapped for meth
710Ns
Rs4 Air Box
Stock Y pipe
Motor build:
Rosten Rods
Cat valve springs, retainers, and lifters
Valve Covers Painted Nogaro Blue
Rs4 motor mounts
re-sealed and refreshed at 68k
Pricey, a little over $8K
Transmission:
JHM Short shifter
LWFW
Vast Stage 4 clutch (12k miles)
RS4 pressure plate
Rs4 Trans mounts
DTS
NO notchyness. Was taken care of extremely well by previous owner.
Suspension:
Stasis TrackSports on sport springs, I also have track springs
Camber plates
Interior:
Raptor Shift light in left center vent comes on at 7100 rpm
Boost gauge up to 45 psi (rare)
Brakes:
Stock brakes front calipers and rotors (car isn't auto crossed. No need for BBK)
S Steal lines
Alcon Rear rotors
Exterior:
3M tape covering front bumper part of the hood and around the rear of each fender.
OEM Rs4 front bumper
Rs4 Foglights
Rs4 Grills
Wheels:
17x9" CCW Classics 255/45/17 faulken- will come with car at full price
Stock 17' Avus wrapped in winter tires if offer less than asking
Extras:
Custom anti theft system. Will only disclose in person.
12 year old car. There are paint imperfections. Touch up on rear bumper, RS4 bumper has light chipping along the upper corners were the bumper meets the front panels. Chip on driver door. Interior is in great shape, minus a little cut in the leather in the rear.
Rear view mirror is on perma dim.
Common pixelization issue.
No CELs or problems. Welcome to take a look or drag to inspection.
|
|
Keywords:
|
2000 Rs6 Turbos, Rods, Valve springs
|
|
|
|
Seller Details
|
|
Senior Member
|
|
Registered: August 2008
Location: Chicago
|
|
|
|
|
Author
|
|
bombermon
Active Member
Registered: October 2008
Location: FL
|
|
Comment Date: Wed June 27, 2012
|
|
This is a really nice one
|
|
|
|
wan2play
Senior Member
Registered: August 2008
Location: Chicago
|
|
Comment Date: Wed June 27, 2012
|
|
thank you. For being 12 years old it is.
Side note. The dyno was done on a 92 degree day with almost 100% humidity. The tune is conservative but would put down another 15 hp tq on a cooler day. And as we all know, mustang dynos read 20-40 points lower, depending on the power.
Car pulls hard on ko4 set ups.
|
|
|
|
|
Grip99
Senior Member
Registered: February 2011
Location: ny, ny
|
|
Comment Date: Wed June 27, 2012
|
|
Very well put together and maintained. I know Mike's shop, Tyrol, does great work. I live 15 mins away.
GLWS!
|
|
|
|
|
wan2play
Senior Member
Registered: August 2008
Location: Chicago
|
|
Comment Date: Fri June 29, 2012
|
|
^thank you
Sale pending at the moment. I will close if sold over the weekend.
|
|
|
|
|
Ldiaz12
Senior Member
Registered: September 2009
Location: Lynn, MA
|
|
Comment Date: Sat July 14, 2012
|
|
I would absolutely love to have this car!
|
|
|
|
|
wan2play
Senior Member
Registered: August 2008
Location: Chicago
|
|
Comment Date: Sat July 14, 2012
|
|
Looks like it is Sold Monday for 15500 without CCWs.
|
|
|
|
|
|
)
